|
Featuers
- Connects
to PC via USB port.
- Embed
high speed CPU.
- Ultra-high
programming speed. Programs 28F320B3
in less than 30 seconds, and
verify it less then 11 seconds.
- 48
ZIP universal drivers. No adapter is needed
for DIP chips48,No
family PACK is needed for any package. Universal DIP, PLCC,
QFP, TSOP, PSOP, SOIC, SSOP, SDIP, uBGA, CSP adapters up to 48
pins. Device specific adapters up to 100 pins are available.
- 0.7V-25.5V/256
levels drivers voltage.
- Support
FLASH, EPROM, EEPROM, MCU, PLD.
- Test
TTL/COMS and SRAM.
- Device
insertion and poor-pin-contact check protect chip from
destroyed. Over-current protection protects pin-drivers from
damaged.
- Surge
check and protect within 1MS.
- Auto-run
mode starts programming automatically upon detection of chip
insertion.
System
requirements
- Operating system: Windows 98/Me/NT/2000/XP
- Processor:
Pentium or Higher
- -
16 MB
RAM minimum, 32 MB recommended
- -
Hard
disk with 8 MB free space
- -
USB port
interface
General
- Power: 100 to 240 VAC, auto-switching
- Freq. range: 47 to 63 Hz
- Power consumption: 25 W
- Operating temperature: 5 to 45 }r |
